Message Board - Bolting
| « up «Posted: 7 Jan 2008 | |
|---|---|
Richard W  - WA, Perth region | New LineHave bolted a new line in Mountain Quarry late last year that is an OPEN project for all - Non chipped and NOT to be chipped. From the anchor/belay of the 1st pitch of "On Edge" follow the obvious line of Fixe P's rightwards through the grove and then directly up and over the bulge. Finish at double P anchor. Should go 26+. Enjoy. |
Replies
ed nepia, 7 Jan 2008 - WA, Perth region
nice work!
Ross, 7 Jan 2008 - WA, Perth region
Credit to you for your generosity Richard. Wherever life takes you, you will be well remembered in these quarters, mate. Pity I can't climb 26!
neil, 7 Jan 2008 - WA, Perth region
can't the little wingman get his skinny arms up it ??
Emil, 27 Jan 2008 - WA, Perth region
had a go today - very stiff -28/9 if i had to hazard a guess. i think cooler temps will see it sent...
richard, noticed that a few bolts were a bit over-sunk, meaning that there is barely enough clearance to get a draw in. just some feedback but great proj!
Richard W, 27 Jan 2008 - WA, Perth region
Ta. Have watched Nick pull the moves - he said it was pretty tough. I'm finding the different size of biners being the variable in the depth i'm sinking the bolts. I do try placing biners in the bolt as I place them and am aware that I'm on the edge of too deep. What did you think of the moves?
Emil, 30 Jan 2008 - WA, Perth region
Yeah moves were hard. Getting to the two gastons wasnt too bad but from there we were shut down. If it were 10 degrees cooler i think we might have a better chance.